Mass Auto Repair Shops
  • Home
  • Types of Repair Shops
    • Auto Body Shops
    • Auto Detailing Shops
    • Auto Glass Shops
    • BMW Repair Shops
    • Engine Rebuilding Shops
    • Inspection Stations
    • Muffler and Exhaust Shops
    • Radiator Shops
    • Towing
    • Transmission Shops
    • Used Auto Parts | Junk Yards

Five Sounds From Your engine, What are they?

3/16/2020

 

Sounds A Car Can Make

Sounds A Car Can Make
​Below are the five main sounds that you will hear coming from internal combustion engines and the reasons why they occurred.

1) Knocking Noises

You will hear knocking noises whenever you accelerate your vehicle or change gears. The knocking will come from the inside of the engine. The sound signifies a problem with the timing of the air and fuel mixture’s ignition within the cylinders of the engine. If the ignition happens too early, then you will hear these knocking sounds. The timing of the ignition is important because it determines whether the proper amount of power is going to be produced. 

A simple engine tune-up for your vehicle might fix the problem. If the sounds still remain, then your engine could have a worn-out component that needs to be replaced or repaired or worse you may need your engine replacement! Anytime you need to have work done on the engine, it is going to cost a lot of money to hire a mechanic for such a task. Before you do this, see if your car has something called a knock sensor that manages these sounds. If it does, then replacing the knock sensor might be all you need to do to eliminate the sounds. 

Also, check the level of the engine oil and verify that it is correct. 

2) Cold Start Rattling Noises

It is natural for some of the newer car engines to rattle a bit during a cold start. The rattle comes from the timing chain that is used with the engine. As the years go by, the engine will start to rattle as it gets older. If you hear these rattling noises, then it likely means your timing chain is wearing out. If you already know that your engine has a timing chain, then you should get it inspected by a mechanic. They have the proper diagnostic equipment to check on it properly. Otherwise, the worn-out timing chain could end up damaging your engine. 

3) Tapping / Clicking Noises

When your engine runs, do you hear constant tapping or clicking noises? If so, this could be the upper valve train that manages the opening and closing of the exhaust valves and air intake valves. You can find out whether the upper valve train is responsible for the noises by removing the engine head and evaluating it. You’ll see the camshaft moving the tappets and the springs returning them into their original positions. If there is reduced oil pressure in the engine or worn-out springs, then these tapping and clicking noises may be heard. Also, check the oil dipstick to check how much oil is in the engine.  Maintenance tip: Get regular oil changes!

4) Shrieking / Squealing Noises

Most people hear squealing and shrieking noises coming from their engine after a while. The belts are actually the parts which generate these noises. The belts connected to the engine are also used to run the AC compressor, power steering pulley and timing. The newer belts are made from rubber instead of chains. A cold started engine will cause the noises to grow louder. As you start driving and accelerating your vehicle, the noises will gradually go away. The belts may slip away from the pulley, which would cause you to hear this noise. Worn out or loose belts often due slip away from their pulleys like this. That is why you need to replace your belts if they appear to be worn out. Either that or tighten the serpentine belt and test to see if you continue to hear the noises. 

5) Grinding Sounds

If you shift gears in a manual transmission vehicle and hear grinding sounds, then it is a transmission issue. The gears in the transmission are probably grinding aggressively against one another. A lot of the older manual vehicles have this problem. Don’t assume the transmission is bad, though, because the transmission may not be able to be disengaged from the engine by the clutch. Either that or the clutch is not being depressed the right away prior to shifting. Get transmission service!

When someone learns how to operate a stick shift for the first time, it is common for them to encounter this problem. In some cases, the clutch mechanism may be too old and worn out rather than the driver’s actions being the cause of the sounds. If you have a worn-out clutch system, then it should be replaced. 

A Little car Care Goes a Long Way - Video

2/23/2020

 
​WATCH - A new video from the Car Care Council, entitled “Auto Care Goes a Long Way,” shows how vehicle owners can save money with some simple preventative maintenance.

That Annoying Check Engine Light is on again!

1/23/2020

 

​Don’t Ignore That Check Engine Light

Check Engine Lights
A lot of people do ignore the little check engine light right under their noses.  That is a BAD IDEA!  If you like spending money on car repairs, then keep driving with that annoying light glowing right in front of you.  But its best to get it checked!  It could be just that you didn’t tighten the gas cap but it could also be something more serious.
​
When the check engine light does go on you may not notice any trouble as you drive over time. But if you choose to ignore it you may begin to notice the car not performing up to its potential or you may experience poor gas mileage.  Not to mention the more you drive your car with a problem usually ends up costing more money in the end!   So get that check engine light diagnosed!

Cooling System Flush

6/27/2018

 

​WHY DO I NEED THE COOLING SYSTEM FLUSHED?

Posted by: Teele Square Auto in Somerville, MA. June  27, 2018
​WHY DO I NEED THE COOLING SYSTEM FLUSHED?
Why do I need the cooling system flushed?
Cooling system flush is part of ongoing preventative maintenance for any vehicle. The cooling system in your car prevents your car from overheating.  Your system circulates mixture of coolant and water throughout your engine.  Unfortunately, the coolant mix becomes contaminated over time with rust and scale, which could cause clogs and damage to the coolant system parts and prevent proper cooling off your engine causing it to overheat.


How your cooling system is flushed:
Our mechanics drain the old coolant mix, flush the system with a coolant cleaner, then we flush the remaining coolant with water.  After the system is flushed and cleaned we fill it back up with the proper mixture of coolant and water then bring the engine up to its running temperature and test the system for leaks and that all other coolant components are working properly.

Recommended Coolant Flush Services:

Your service manual should have recommendations of when to get It’s a good idea to change the coolant.  For quick reverence though, every 40,000 to 50,000 miles or whenever the low coolant level light is on or the check engine light is on is a good idea to check or replace the coolant on your car.  Additionally, if your car is overheating it may be time for the coolant to be replaced.

Visit Teele Square Auto for your Cooling System Flush:
Teele Sq Auto
1284 Broadway
Somerville, MA
(617) 623-9067

New Auto Repair Shop in Malden, MA

2/8/2018

 
Eli & Gary's Automotive Services
​On the corner of Beach and Salem st in Malden is an auto repair shop that was once a thriving repair shop and gas station called Amatos Auto Repair and then Gary’s Auto Services.

Recently the property at 12 Beach St was purchased by Eli H.........., the owner of Teele Sq Auto in Somerville who also owns Eli’s Service Station in Arlington. This is a good thing for the Linden neighborhood of Malden.  I have seen the transformation of the above mentioned auto repair shops by Eli.

The improvements will be good for the neighborhood as Eli plans big things for the Malden location including a complete makeover of the exterior of the building, repaving of the large lot, new signage and new lights to properly illuminate the property.

The shop has a new name, Eli & Gary’s Automotive Services and will be providing complete auto repair and maintenance services on all foreign and domestic cars, trucks, SUV’s, and vans. In addition to car repair, Malden residents will be able to get there cars inspected their as soon as they become a Mass Inspection Station.

If you live or work in the Malden area you won’t be disappointed with the auto repair services you will find at Eli & Gary’s Automotive Services!

Eli & Gary's Automotive Services

Eli & Gary's Auto Motive Services
​12 Beach Street
Malden, MA 02148
(781) 321-0880

How to find a good auto repair shop

11/27/2017

 
There are many things to consider when looking for an auto repair shop from reputation to car repair estimates to certified auto repair shops.  Learn more from about "how to find a good auto repair shop"

Car Repair Malden, MA

12/13/2016

 
PictureLou and Brian
I recently moved to Malden, MA a few months ago.  After finally unpacking and getting organized I decided to venture out in search of an car repair shop that could handle maintenance and repairs on my car.  I drove around to several repair shops, there are a lot of shops in Malden, and stopped in on a couple shops to chat with the mechanic or owner.  The only shop that peaked my interest was a place called Hub Starters on Broadway in Malden.  My first reaction was, why is this place named Hub Starters?  Well as it turns out the name fits as the business model from over 35 years ago was to be the hub of automobile and truck starter repair and rebuilding that morphed into a complete auto repair shop.

With so many choices for car repair shops in Malden here are the top 3 things I liked about Hub Starters:
  • They are the only AAA repair shop in Malden, MA
  • Over 35 years in business
  • Mass State inspection station
Since moving into Malden I used Hub Starters two times, the first time for an inspection sticker and an oil change, then a couple months later for a brake job.

​Anyone new to the Malden area looking for an auto repair shop should look no further then Hub Starters.

​Synthetic oil – Is it right for my car?

10/25/2016

 
Synthetic Oil Change
Even though synthetic oil is more expensive it has its advantages.  Synthetic oil takes longer to breakdown so lasts longer than conventional motor oil.  Eli of Teele Square Auto in Somerville, MA says “customers that once changed their oil every 3,500 miles now go 7,000 miles between oil changes using synthetic oil"

Some car-makers require owners to use synthetic oil so be sure to check your owner’s manual.  Harry Janice of West Lynn Auto in Lynn, MA warns owners to be sure to comply with your warranty to avoid from voiding it if you don’t comply.

For older cars, synthetic motor oil has a resistance to breaking down which will help prolong the life of an older engine.  Additionally, older engines using conventional oil can began to get sludge buildup from conventional oil breaking down. Using synthetic oil for on older engines would be less likely to breaking down.  In a nut shell using synthetic oil is will prolong the life of your engine and require less oil changes says, Steve of Waverly Square Auto in Belmont MA.

Acura Repair Specialist - LBJ Honda of Melrose, MA

3/4/2016

 
LBJ Honda/Acura Specialists Melrose MA
Melrose, MA - LBJ Honda/Accura Specialists located in Melrose has served Honda and Acura owners in Middlesex County for over30 years now.

Personalized service is the backbone of our operation. Unlike most auto repair shops, we welcome you into our service bays. Our expert staff will be glad to walk you through the diagnosis of your car’s problem and explain the necessary repairs.

At LBJ, factory-trained technicians, state-of-the-art equipment, and the right attitude add up to quality service at a reasonable price.

​Over three decades and still going strong!

LBJ Honda Melrose MA
 In 1973 a young man with a degree in mechanical engineering found himself looking for employment. Jobs in his field were scarce, so he started to work as a mechanic in a Volvo/Honda auto dealership.

At some point, everyone experiences a life-changing moment. This was his. Barry Innerfield (for that was the young man’s name) fell passionately in love with the little Honda Civic. (We still have one here!)

The course of true love never runs smooth. After Barry left the auto dealer, he spent several years trying other jobs in both mechanical engineering and auto repair. But he never forgot his dream of having a Honda repair shop of his own. In 1986 Barry located space in Melrose, Massachusetts, and opened LBJ. (The initials were for the members of his family, Liuda, Barry, and Jerry.)

PROVIDING SUPERIOR SERVICE, MAINTENANCE & REPAIR FOR YOUR HONDA OR ACURA!

"The factory-trained technicians and state-of-the-art equipment are only part of the LBJ difference. Our true pride is providing personalized service, with the right attitude, to make sure your experience at LBJ Honda is always a positive one."
To schedule an appointment please call us at (781) 662-5300
Or visit us online at www.lbjhonda.com
​Your vehicle will thank you!

​Massachusetts Minimum Tire Tread Depth 

11/24/2015

 
Good information regarding tire tread depth in Massachusetts.  
Click>>>Massachusetts Minimum Tire Tread Depth by Teele Sq Auto Somerville, MA
 Published by Teele Square Auto in Somerville, MA​
<<Previous

    Contributions from Mass Auto Repair Shops

    Archives

    March 2020
    February 2020
    January 2020
    June 2018
    February 2018
    November 2017
    December 2016
    October 2016
    March 2016
    November 2015
    October 2015

    Categories

    All
    Acura
    Auto Repair Shops
    Car Care Tips
    Car Noises
    Cooling System Flush
    Honda
    Oil Change
    Preventative Maintenance
    Tire Tread Depth

    RSS Feed

Add Your Business to MassAutoRepairShops.com
Auto Repair Shop Marketing
Mass Auto Repair Blog

Privacy Policy
About
Copyright © 2019 - 2021